NEC RT50X User Manual
                                                  | |
Contents
| 
E – 24POWERSTATUSPOWERSTATUSPOWERSTATUSPOWERSTATUSPOWERSTATUS OFF ONPOWER2. Turn on and off the Rear projection display.3. OPERATIONAC INMAIN POWERONOFFThis section describes how to select a computer or video source, howto adjust the picture, and how to customize the settings.Connecting the Power Cable and Turning on theRear projection displayBefore you turn on your rear projection display, ensure that the com-puter or video source is turned on.1. Connect the supplied power cable to the rear projection display.Plug the supplied power cable in the wall outlet and then press themain power switch [ I ] on the rear terminal panel. The rear projec-tion display will go into its standby mode and the power indicator willglow orange.Main power switchMENUOFFVIDEO S-VIDEO RGB AUTO ADJ.ONSELECTPOWERPOWERSTATUSON / STAND BY VIDEOS-VIDEOTo turn on the rear projection display:Only after you press the "ON/STAND BY" button on the cabinet or "POWER ON" button on the remote control will the power indicator turn to greenand the rear projection display become ready to use.NOTE: To turn the rear projection display on by pressing the main power switch [ I ], use the menu and enable the "Auto Start" feature. (See page E-35.)NOTE: Immediately after turning on the rear projection display, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.Status of Indicators:Stand bySteady orange lightPOWER indicator flashing ingreen for 1 minute.Lamp Mode:Normal modeLamp Mode:Eco modePOWER indicator steadylight in green.STATUS indicator flashing ingreen for 3 minutes. During thisperiod of time Normal mode isforcefully selected.STATUS indicator steadylight in green (Eco mode)POWER indicator flashing ingreen for 1 minute. POWER indicator steadylight in green. |
Related manuals for NEC RT50X
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine