NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual

Also see for SVP SERVER -: Brochure

NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual Manual pdf 36 page image

4-6 Configuring the SVP ServerSVP Server Installation, Setup, & Maintenance Manual - Revision 1Send AllIn an IP system with multiple SVP Servers, the SendAll option isprovided to speed configuration and ensure identical settings.The S=SendAll option allows you to send that configuration parameterto every SVP Server on the LAN. SendAll can only be used after theIP address is established on EACH SVP Server via the serial connection.If you anticipate identical settings across the LAN, set just the IPaddress and custom hostname (if desired) for each SVP Server usingthe initial serial connection. Then connect via the LAN and use SendAllto set identical configuration options for all SVP Servers.If SendAll is to be utilized in your system, all passwords must beidentical. DO NOT CHANGE THE PASSWORD AT THE INITIALCONFIGURATION IF THE SEND ALL OPTION IS DESIRED. Use thedefault password and change it globally if desired after a LAN connectionis established for all SVP Servers.If independent administration of each SVP Server is desired, thepasswords may be set at initial configuration.SVP Server ConfigurationThe type of gateway you are using determines the mode of the SVPServer. Select from either the 'Netlink' or 'Netlink IP' to interfacewith the Telephony Gateway or IP Telephony Server respectively. TheSVP-II Configuration window(Figure 4-3) is where the mode of SVPServer is set. It is also the menu used to lock the SVP Serverfor maintenance and reset the Server after maintenance.The SVP Server automatically locks for maintenance if the IP addressis changed. When this Maintenance Lock occurs, the SVP Server mustbe reset upon exit. All active calls are terminated during a reset.The SVP Server window also displays options for the TelephonyGateway system configuration. Use the following steps to complete theConfiguration window.Step 1 Select SVP-II Configuration on the System menu (Figure 4-1 on page4-2) and press ENTER. The SVP-II Configuration window displays(Figure 4-3).NOTETo change the IP address of the master SVP Server, change it in this menu andreboot the system. Then you may change alias IP addresses in each of the otherSVP Servers without error.