NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual

Also see for SVP SERVER -: Brochure

NEC SVP SERVER - INSTALLATION SETUP AND Installation And Setup Manual Manual pdf 43 page image

5-1SVP Server Installation, Setup, & Maintenance Manual - Revision 15Swapping/Adding/Deleting SVPServersThis chapter describes how to swap, add, and delete SVP Servers.Chapter Topics • IP System• UNIVERGE WL System Telephony GatewayIP SystemWhenever a SVP Server is removed from the system, WirelessTelephones that are using the SVP Server will be affected. If theremoval of the SVP Server is intentional, the administrator should lockand idle the system prior to removing a SVP Server.Whenever a SVP Server is added to the system, the change isseamless and does not affect Wireless Telephone calling functionality.Adding a SVP ServerIn the IP PBX environment, a new SVP Server is detected within twoseconds of being added to the system (booted/configured/connected).When detected, any Wireless Telephone not active in a call willimmediately be forced to check-out and check-in again. Any WirelessTelephone in a call will immediately switch to the SVP Server thatshould provide its “timing” function. This switch should not benoticeable to the user since it is similar to a normal handoff betweenaccess points. When the Wireless Telephone ends the call, it will beforced to checkout and checkin again.Removing a SVP ServerWhen a SVP Server is removed from the system it is detected withintwo seconds. Wireless Telephones not in calls are immediately forced tocheckout and checkin again.