Chapter 4 - Terminals and Optional EquipmentChapter 4 4 - 71SECTION 4-18TERMINAL LEGS4.18.1 Using the Terminal LegsThe UX5000 terminals provide two legs for angling the terminal to best suit each user (this is in addition to thedisplay positioning provided by display terminals). The legs can be set for four different heights.4.18.2 Adjusting the Leg Height (Figure 4-33 - Figure 4-34)1. When first placing a terminal, the upper and lower legs are folded out flat. Rotate the lower leg (located atthe front of the terminal) towards the back. Lower the upper leg down and gently press the left and rightsides into the lower leg. Note that the upper leg has 2 small tabs that fit into notches on the lower leg.After positioning these tabs over the notches, gently press the upper leg down until it clicks into place inthe lower leg. This is the first position.Figure 4-33: RAISING THE TERMINAL HEIGHT2. To set to the second, third, and forth positions, gently press the lower leg down untiil the upper leg clicksinto the desired position..Figure 4-34: INCREASING THE TERMINAL HEIGHT3. To set the terminal back to a lower position, first gently press the lower leg down to unsecure the upperleg. Then gently lift the upper leg up and slide it to the desired position.
