NEC Univerge SV9300 Series User Manual

Also see for Univerge SV9300: User guide Programming guide User guide User guide Networking manual

Contents

NEC Univerge SV9300 Series User Manual Manual pdf 78 page image

TRUNK QUEUING -OUTGOINGThis feature allows a terminal user, uponencountering a busy signal on a trunk, to set a calland enter a first-in, first-out queue. As soon as anoutgoing trunk becomes available, terminals in thequeue will be called back on a first-in, first-outbasis.This feature is set by Soft key or feature key.The feature key is set by system data settingat initial installation. For details, pleasecontact the system administrator.TO SET TRUNK QUEUING –OUTGOINGThis feature is available only for the terminalthat is set by system data setting at initialinstallation.1. Press Speaker key and dial theoutgoing access code.Speaker key lamp lights red. →Line key lamp lights red. →The lines are all busy status.You will receive a busy tone.BUSY 26-255XX4:26 PM MON 11 MAY 2015CB2. Press Soft key (CB) or TrunkQueuing - Outgoing feature key.You will receive a service set tone.Outgoing feature key lamp lights red. →3. Press Speaker key.Speaker key lamp goes off. →Wait until the outgoing line is available.SET 26-255XX4:26 PM MON 11 MAY 2015WHEN TRUNK IS AVAILABLE1. Ringing of external incoming call isheard.Call Indicator Lamp flashes red.Line key lamp flashes green. →CALL BACK 26-255XX4:26 PM MON 11 MAY 2015Recall PICK >>>>2. Lift the handset or press Speakerkey.Outgoing feature key lamp goes off. →Call Indicator Lamp goes off.Line key lamp lights green. →3. Dial the desired number.81XXXXXXXXXX4:26 PM MON 11 MAY 2015Recall VOICE CB >>>>TO CANCELThis feature is available only for the terminalthat is set by system data setting at initialinstallation. This feature cannot be canceledby Soft key.1. Lift the handset.Line key lamp lights red. →2004:26 PM MON 11 MAY 2015Recall PICK >>>>2. Press Trunk Queuing – Outgoingfeature key.You will receive a service set tone.Trunk Queuing – Outgoing feature iscancelled.Outgoing feature key lamp goes off. →CANCEL4:26 PM MON 11 MAY 20153. Replace the handset.Line key lamp goes off. →FEATURE OPERATION70