VOICE FIRST/TONE FIRSTThis feature allows incoming calls to your terminalto either ring or go to voice announcement.The feature access code/feature key is set bysystem data setting at initial installation. Fordetails, please contact the systemadministrator.TO SET VOICE FIRST/TONEFIRST MODE1. Press Speaker key.You will receive a dial tone.Speaker key lamp lights red. →2. Dial Voice First/Tone First accesscode or press Voice First/Tone Firstfeature key.LCD shows current mode.You will receive a feature dial tone.VOICE4:26 PM MON 11 MAY 2015Recall PICK >>>>3. Dial any single digit ( - ).Voice First mode is switched to Tone Firstmode (or vice versa).You will receive a feature set tone.TONE4:26 PM MON 11 MAY 2015Recall PICK >>>>4. Press Speaker key.Speaker key lamp goes off. →5. The called party can reply.WHEN A CALLED TERMINALHAS BEEN SET TO VOICEFIRST1. Press Speaker key.You will receive a dial tone.Speaker key lamp lights red. →Line key lamp lights green. →2. Dial extension number.Wait for voice page alert tone.VOICE CALL 2004:26 PM MON 11 MAY 2015R-TONE MIC3. Speak to the called party.4. Dial .The called party's extension will ring.2004:26 PM MON 11 MAY 2015R-TONE MICWHEN A CALLED TERMINALHAS BEEN SET TO TONEFIRST1. Press Speaker key.You will receive a dial tone.Speaker key lamp lights red. →Line key lamp lights green. →2. Dial extension number.The called party's extension will ring.2004:26 PM MON 11 MAY 2015R-TONE MIC3. Dial .Wait for voice page alert tone.VOICE CALL 2004:26 PM MON 11 MAY 2015R-TONE MIC4. Start conversation with called party.5. The called party can reply.FEATURE OPERATION80
