3-18 Setting Up and Using the SoftwareType the following at the DOS prompt and press Enter.copy CONDS.SYS CONFIG.SYS3. Dock your NEC Versa and reboot the system. Thedocking station configuration will be used.4. To switch to the mobile configuration, copy the mobilesystem files, undock the NEC Versa, and reboot.The SCSI Configuration DriverYour Docking Station 4000 comes with an external as wellas an internal SCSI port. Plug and Play systems, like theNEC Versa 4000, take control of this port and its settings.However, if your system is a non-Plug and Play system,you may need to specify some settings for the port. TheSCSI Configuration driver included with the Setup utilityprovides a means for specifying port settings.If you have a Plug and Play system, you donot need to use the SCSI Configuration driver. Yousystem automatically assigns the addresses andinterrupts to use.Using the DriverThe SCSI port on the back of the docking station has thefollowing power-on defaults:n SCSI Port: Enabledn I/O Address: 0140-15Ehn IRQ: Enabledn IRQ: 10n DMA: Enabledn DMA: 7.
