4-14 Using the Operating System and UtilitiesDo not turn off or disturb the system during the recoveryprocess.7. When the recovery process is complete, you are prompted to remove the CD fromthe CD-ROM drive and reboot your system.8. Press Enter, click Reboot, or press Alt-R to reboot your system.A series of hardware detection screens display, the system reboots and theWindows Setup screen appears. Follow the on-screen instructions to set upWindows.You are required to reenter your Microsoft license number.Partition Only RestoreIf your preinstalled software on drive C: of your multiple partitioned drive becomesunusable and you cannot boot from the hard disk, use the Product Recovery Utility torestore your primary partition to its initial shipping configuration.Use the Partition Only restore option only if your hard diskdrive consists of multiple partitions and if drive C: contains the operating system andrelated drivers. Move all other data and applications to other partitions (drives) or thePartition Only restore process will erase them completely.The Partition Only restore option deletes all files on drive C: and replaces them with theoriginal factory installed files. Only use the Partition Only restore option if thepreinstalled software on drive C: is unusable.For important information about partitioning your hard disk drive, see the section,“Partition Magic,” earlier in this chapter.Use the Product Recovery Utility to perform a Partition Only restore as follows:1. Check the Product Recovery CD title and make sure that it is the correct CD foryour NEC Versa computer and operating system.2. Put the CD into the CD-ROM drive tray, close the drive door, and reboot yourcomputer.3. Read the License Agreement screen that appears. Use the VersaGlide touchpad toposition the cursor on the Accept button. Left click to accept the agreement.You have the option of accepting or declining the agreement. If you decline theagreement, the recovery utility exits.
