NEC VT46 User Manual

Also see for VT46: Control commands Specifications Quick connect guide Quick connect guide Release note

NEC VT46 User Manual Manual pdf 15 page image

E-15PROJECTING AN IMAGE (BASIC OPERATION)This section describes how to turn on the projector and to project apicture onto the screen.Turning on the ProjectorNOTE:• The projector has two power switches: main power switch and POWER (ON/STAND BY) button.• When plugging in or unplugging the supplied power cable, make sure that themain power switch is pushed to the off (O) position. Failure to do so maycause damage to the projector.To turn on the main power to the projector, press the Main Power switchto the on position ( I ).Before you turn on your projector, ensure that the computer or videosource is turned on and that your lens cap is removed.Only after you press the POWER (ON/STAND BY) button on the pro-jector cabinet or the remote control for a minimum of 2 seconds will thepower indicator turn to green and the projector become ready to use.Note on Startup screen (Menu Language Select screen)When you first turn on the projector, you will get the Startup screen. Thisscreen gives you the opportunity to select one of the 19 menu languages:English, German, French, Italian, Spanish, Swedish, Japanese, Korean,the Simplified Chinese, Polish, Hungarian, Russian, Greek, Turkish,Dutch, Norwegian, Finnish, Portuguese and Czech.To select a menu language, follow these steps:1. Use the SELECT Gor Hbutton to select one of the 19 languages forthe menu.After this has been done, you can proceed to the menu operation.If you want, you can select the menu language later. See "Language"on page E-22.NOTE: Immediately after turning on the projector, screen flicker may occur. Thisis not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.If one of the following things happens, the projector will not turn on.* If the internal temperature of the projector is too high, the projectordetects abnormal high temperature. In this condition the projectorwill not turn on to protect the internal system. If this happens, wait forthe projector's internal components to cool down.* When the lamp reaches its end of usable life, the projector will notturn on. If this happens, replace the lamp.* If the lamp fails to light, and if the STATUS indicator flashes on andoff in a cycle of six times, wait a full minute and then turn on thepower.2. Press the ENTER button to execute the selection.Selecting a SourceSelecting the computer or video sourceUsing the Remote ControlPress the SOURCE button.Using the cabinet buttonsNOTE: If no input signal is available, the projector will display a blue background(factory preset).Press any one of the RGB,VIDEO or S-VIDEO buttons.