NEC VT46 User Manual

Also see for VT46: Control commands Specifications Quick connect guide Quick connect guide Release note

NEC VT46 User Manual Manual pdf 26 page image

E-26Cleaning the Cabinet and the LensCleaningCleaning or Replacing the FilterThe air-filter sponge keeps the inside of the projector from dust or dirtand should be cleaned after every 100 hours of operation (more often industy conditions). If the filter is dirty or clogged, your projector may over-heat.CAUTION• Turn off the projector, turn off the main power switch and un-plug the projector before replacing the filter.• Only clean the outside of the filter cover with a vacuum cleaner.• Do not attempt to operate the projector without the filter cover.To clean the air-filter:Vacuum the filter-through the filter cover.CatchTo reset the filter usage time, from the menu, select [Default] → [ClearFilter Usage].See also page E-24 for resetting the filter usage time.To replace the filter (sponge):1. Remove the filter cover by pushing up on the catch of the cover untilyou feel it detach.2. Gently peel off the filter (sponge) and replace it with the new one.3. Reinstall the new filter cover.NOTE: Do not wash the filter with soap and water. Soap and water will damagethe filter membrane. Before replacing the filter, remove dust and dirt from theprojector cabinet. Keep out dust and dirt during filter replacement.NOTE: When you replace the lamp, it is also wise to replace the filter. The filtercomes in the same package with your replacement lamp.1. Turn off the projector before cleaning.2. Clean the cabinet periodically with a damp cloth. If heavily soiled,use a mild detergent. Never use strong detergents or solvents suchas alcohol or thinner.3. Use a blower or lens paper to clean the lens, and be careful not toscratch or mar the lens.