NEC VT46 User Manual

Also see for VT46: Control commands Specifications Quick connect guide Quick connect guide Release note

NEC VT46 User Manual Manual pdf 8 page image

E-81. RGB IN / Component Input Connector (Mini D-Sub 15 Pin)Connect your computer or other analog RGB equipment such as IBMcompatible or Macintosh computers. Use the supplied RGB cable toconnect to your computer. This also serves as a component inputconnector that allows you to connect a component video output ofcomponent equipment such as a DVD player. This connector alsosupports SCART output signal. See page E-12 for more details.2. RGB AUDIO Input Mini Jack (Stereo Mini)This is where you connect the audio output from your computer orDVD player when connected to the RGB input. A commercially avail-able audio cable is required.3. S-VIDEO IN Connector (Mini DIN 4 Pin)Here is where you connect the S-Video input from an external sourcelike a VCR.NOTE: S-Video provides more vivid color and higher resolution than the tra-ditional composite video format.S-VIDEO AUDIO Input Jacks R/L (RCA)These are your left and right channel audio inputs for stereo soundfrom an S-Video source.4. VIDEO IN Connector (RCA)Connect a VCR, DVD player, laser disc player, or document camerahere to project video.VIDEO AUDIO Input Jacks R/L (RCA)These are your left and right channel audio inputs for stereo soundfrom a Video source.5. PC CONTROL Port (DIN 8 Pin)Use this port to connect your PC to control your projector. This en-ables you to use your PC and serial communication protocol to con-trol the projector. If you are writing your own program, typical PCcontrol codes are on page E-32.Terminal Panel Features12 534Part Names of the Remote Control1. Infrared TransmitterDirect the remote control toward the remote sensor on the projectorcabinet.2. MENU ButtonDisplays the menu for various settings and adjustments.3. SELECT GHFE / Volume ButtonsGH : Use these buttons to select the menu of the item you wishto adjust.FE : Use these buttons to change the level of a selected menuitem. A press of the E button executes the selection. Whenno menus appear, these buttons work as a volume control.4. ENTER ButtonExecutes your menu selection and activates items selected from themenu.5. CANCEL ButtonPressing this button will return to the previous menu.While you are in the main menu, pressing this button will close themenu.6. POWER Button (ON/STAND BY) ( )Use this button to turn the power on and off when the main power issupplied and the projector is in standby mode.To turn on the projector, press and hold this button for a minimum oftwo seconds. To turn off the projector, press this button twice.7. SOURCE ButtonPress this button to select a video source such as a PC, VCR or DVDplayer. Each time this button is pressed, the input source will changeas follows:RGB → Video → S-Video → RGB → ...8. ASPECT ButtonPress this button to display the Aspect Ratio select screen. See pageE-22.9. MUTE ButtonThis button turns off the image and sound for a short period of time.Press again to restore the image and sound.1468 97325