NEC VT650 User Manual

Also see for VT650: Specification Quick connect guide Specifications Installation data

Contents

NEC VT650 User Manual Manual pdf 16 page image

E–10Top Features1. Power Button (ON / STAND BY)Use this button to turn the power on and off when the power issupplied and the projector is in standby mode.NOTE: To turn off the projector, press and hold this buttonfor minimum of two seconds.2. Status IndicatorWhen this is lit red continually, it’s warning you that theprojection lamp has exceeded 2000 hours (up to 3000 hours inEco mode) of service. After this light appears, it is advisableto replace the projection lamp as soon as possible. (See pageE-38). In addition the message “The lamp has reached theend of its usable life. Please replace the lamp.” appears eachtime the projector is turned on until the lamp is replaced.If this light blinks red rapidly, it indicates that the lamp coveror filter cover is not attached properly or the projector is over-heated. See the Power / Status Light Messages on page E-40for more details.3. Power Indicator ( )When this indicator is green, the projector is on; when theindicator is orange, it is in standby mode.4. Select ( ) / (+) (–) Buttons: Use these buttons to select the menu of the item youwish to adjust.: Use these buttons to change the level of a selectedmenu item.When an image is magnified, these buttons can be used tomove the image on screen.5. Cancel ButtonPress this button to exit the menu. While you are in the adjust-ment or setting menu, pressing this button will return to theprevious menu.6. Enter ButtonExecutes your menu selection and activates items selected fromthe menu.7. Menu ButtonDisplays the menu.8. Auto Adjust ButtonUse this button to adjust Position-H/V and Pixel Clock/Phasefor an optimal picture. Some signals may not be displayedcorrectly or take time to switch between sources.9. Source ButtonUse this button to select a video source such as a PC, VCR orDVD player.Each time this button is pressed, the input source will changeas follows:→ RGB → Video → S-Video → RGB ...If no input signal is present, the input will be skipped.MENUENTERCANCELSELECTPOWERSTATUSON/STAND BYSOURCEAUTO ADJUST938741265