E–35SetupPage1 Page2 Page3 Page4RGBVideoS-VideoAutoAutoAutoSignal SelectWhen this feature is turned on, the “No Input” message willappear if there is no signal present.This option turns on or off the volume bar when you adjustthe sound volume using VOL+/-(up and down) button.On: You can increase or decrease the sound vol-ume with the volume bar on screen.NOTE: If no adjustments are performed within 3 seconds,the Volume bar will disappear.Off: You can increase or decrease the sound vol-ume without having to use the volume bar.This option is available on the optional presentation remotecontrol (PR51KIT) only. This option turns on or off the key-stone bar when you adjust the keystone using KEYSTONE+/- button on the optional presentation remote control.On: You can increase or decrease the level withthe keystone bar on screen.Off: You can increase or decrease the level with-out having to use the keystone bar.Clean Filter: This option turns on or off the “Please cleanthe filters” message each time you turn on the projector ifthe projector has been used in excess of 100 hours of use.On: The message to clean the filters will be dis-played.Off: The message will not be displayed.See page E-39 for cleaning the filters. After cleaning the fil-ters, reset the filter usage back to zero. To reset the filterusage, see page E-37.This option allows you to select how long the projector waitsafter the last touch of a button to turn off the menu.The preset choices are "Manual", "Auto 5 sec", "Auto 15sec", and "Auto 45 sec". The "Auto 45 sec" is the factorypreset.Manual: The menu can be turned off manually.Auto 5 sec: The menu will automatically be turned offin 5 seconds if no buttons are pressed within5 seconds.Auto 15 sec: The menu will automatically be turned offin 15 seconds if no buttons are pressedwithin 15 seconds.Auto 45 sec: The menu will automatically be turned offin 45 seconds if no buttons are pressedwithin 45 seconds.Signal Select:Allows you to choose "RGB" for an RGB source such as acomputer, or "Component" for a component video sourcesuch as a DVD player. Normally select "Auto" and the pro-jector automatically detects a component signal. Howeverthere may be some component signals that the projector isunable to detect. If this is the case, select "Component".Select “Scart” for the European Scart.This feature enables you to select composite video standardsmanually. Normally select "Auto".When you select the video standard for Video and S-Video,select the video standard from the pull-down menu.This must be done for Video and S-Video respectively.SetupPage1 Page2 Page3 Page4Orientation Desktop FrontTopCinema PositionLogoBackground[Page2] (Advanced mode)AutoNTSC 3.58NTSC 4.43PALPAL-MPAL-NPAL 60SECAMSetupEnables you to set operating options.[Page1]This reorients your image for your type of projection.The options are: front floor projection, rear ceiling projec-tion, rear floor projection, and front ceiling projection.This feature selects the vertical position of the image whenviewing video with Cinema aspect ratio selected.When Cinema aspect ratio is selected on earlier models, theimage is displayed with black borders on the top and bot-tom. You can select the vertical position among three op-tions:Top: Image position is at the top with a black bor-der on bottom.Center: Image position is at the center with blackborders on top and bottom.Bottom: Image position is at the bottom with a blackborder on top.Use this feature to display a black/ blue screen or logo whenno signal is available.
