NEC VT650 User Manual

Also see for VT650: Specification Quick connect guide Specifications Installation data

Contents

NEC VT650 User Manual Manual pdf 22 page image

E–16This section describes how to set up your VT650 projector andhow to connect video and audio sources.Setting up Your ProjectorYour VT650 Projector is simple to set up and use. But beforeyou get started, you must first:1. Determine the image size.2. Set up a screen or select a non-glossy white wall onto whichyou can project your image.Carrying the Projector: Always carry your projector bythe handle. Ensure that the power cable and any other cablesconnecting to video sources are disconnected before moving theprojector.When moving the projector or when it is not in use, cover thelens with the lens cap.MENUENTERCANCELSELECTPOWERSTATUSON /OFFSOURCE AUTO ADJUSTScreenTop viewScreenSide viewMENUENTERCANCELSELECTPOWERSTATUSON/OFFSOURCEAUTO ADJUSTRGBINPUTOUTPUTAUDININOUTOUTPC-CONTROL S-VIDEO VIDEOMENUENTERCANCELSELECTPOWERSTATUSON/OFFSOURCEAUTO ADJUSTRGBINPUTOUTPUTAUDINOUTPC-CONTROL S-VIDEO VID21MENUELLECTSOURCEAUTO ADJUSTRGBINPUTOUTPUTAUDINOUTPC-CONTROL S-VIDEO VIDAdjusting the Tilt Foot1) Press and hold the Tilt button on the front of the pro-jector.2) Lift the front edge of the projector to the height youwant, and release the button to lock the AdjustableTilt Foot.To fine-tune the image’s position vertically on the screen,rotate the foot. Each of the rear feet height can bechanged up to 0.6” (4mm).Carrying handle2. INSTALLATIONSelecting a LocationThe further your projector is from the screen or wall, the largerthe image. The minimum size the image can be is approximately25" (0.64 m) measured diagonally when the projector is roughly3.5 feet (1.1 m) from the wall or screen. The largest the imagecan be is 300" (7.6 m) when the projector is about 36.6 feet (11.2m) from the wall or screen.Using a Tabletop or Cart1. Place your projector on a flat level surface at the optimal dis-tance from the screen or wall so you realize the size imageyou want. (Avoid having bright room lighting or sun lightdirectly on the screen or wall where you’ll be projecting theimage.)2. Connect the power cable, remove the lens cap and turn theprojector on. (If no input signal is available, the projectorwill display a background image.)3. Ensure that the projector is square to the screen.4. Move the projector left or right to center the image horizon-tally on the screen.5. To center the image vertically, lift the front edge of the pro-jector and press the One-Touch Tilt button on the front sideof the projector to release the Front Adjustable foot.(There is approximately 10 degrees of up and down adjust-ment for the front of the projector.)6. If the projected image does not appear square to the screenthen use keystone correction for proper adjustment.7. Adjust the size of the image using the Zoom lever on thelens.MENUENTERCANCELSELECTPOWERSTATUSON/OFFSOURCE