NEC XG85-XG135LC - 1 Manual

Also see for MultiSync XG-1352: Operation manual User manual

Contents

NEC XG85-XG135LC - 1 Manual Manual pdf 38 page image

38123456123456123456123456123456123456123456 ADJUSTMENT.Set-Up ProcedureBefore adjusting1 Installation of the projector.• This projector is pre-adjusted at the factory for 100 inch screen front projection at 12.4˚ for XG85 and 12.2˚ forXG135LC, and ceiling mounting. If your application is the same as the factory setting, you will not have toreconfigure the projector for your application. However, if you want to do some fine or further adjustments, carry outthe following adjustments.2 Connect the external equipment to the projector.3 Turn on power to the external equipment and the projector.• If you want to institute the use of a passcode, register the passcode. See page 62.• Carry out the adjustments after displaying an image for 20 minutes or more.4 Select the input signal.• If your input signal has not been recorded, it is necessary to perform the signal entry beforehand. See page 19.If you want to use the projector in any other configuration than the factory setting, perform the following after installation.1) Electrical Focus Adjustment See page 392) Alignment Adjustment See page 433) Static Convergence Adjustment See page 504) Dynamic Convergence Adjustment See page 51Check and adjust againif necessary5) Color temperature & White Balance Adjustment See page 596) R, G, B Gain Adjustment See page 60(only when used with the ISS-6020/ISS-6020G)*If a wrong button is pressed accidently, an error message will appear.*Pressing the HELP button will display a brief description of theselected function and button operation instructions.