78SETTINGS-Video Mode Selection– A D J U S T –1 / S I G N A L E N T R Y2 / F O C U S3 / A L I G N M E N T4 / C O N V E R G E N C E5 / K E L V I N6 / R , G , B G A I N7 / P A S S C O D E8 / O P T I O N9 / R E F . A D J U S T– O P T I O N –1 / S E T T I N G M O D E2 / M E N U M O D E3 / S E Q U E N C E R4 / P J A D D R E S S5 / V E R S I O N6 / H O U R M E T E R7 / D E F A U L T D A T AP01/P03 OPTION – SETTING MODE –CONNECT CONDITIONCEILINGFRONTDEFAULT INPUT SELECTFOCUS EDGE MODE ALLS-VIDEO MODE SELECT S2VIDEO MODE SELECT AUTOSTANDALONELASTPJ ORIENTATIONThis function is used to select the S-video signal detection mode.This allows identifying of the S-video signals with different aspectratio: squeeze or full mode (CINEMA 16 : 9) and letter box (WIDE4 : 3) signals.To set, proceed as follows:NOTE: An identifying result will be displayed in the SOURCEINFORMATIONscreen.1 Press the ADJUST button to display the “ADJUST” menu.• The projector may ask you to enter your passcode.See page 61 for the explanation of the PASSCODE.2 Use the CURSOR or button to highlight the “8/OPTION”line. Press ENTER to display the “OPTION” menu. You can alsoselect the “OPTION” menu directly by pressing the INPUT “8”button.3 Use the CURSOR or button to highlight the “1/SETTINGMODE” line. Press ENTER to display the “SETTING MODE”menu. You can also select the “SETTING MODE” menu directlyby pressing the INPUT “1” button.4 Use the CURSOR or button to select the “S-VIDEO MODESELECT” item, then press ENTER to display the “S-VIDEOMODE SELECT” menu.NOTE: The SETTING MODE has three menus. The “S-VIDEOMODE SELECT” menu is on the first menu (P01). To accessP02 or P03 from P01, press and hold down the CTL button thenpress the button; to return to P01 from P02 or P03, pressand hold down the CTL button then press the button.