35abccba3 Finally adjust the focus using the FOCUS+-buttons either of the remote control or the projec-tor.Note:If you use the lens memory for adjustment of the focus, first movethe key (Focus Down) almost to the limit and then make adjust-ments so that you can finish the adjustment on the (Focus Up)side.x-direction fixing levers7-2-3. Adjustments of Anamorphic LensHere you will adjust the mounting positions (vertical, horizon-tal and depth) of the anamorphic lens, and its tilt/pan anglesand focusing as well. Move the anamorphic lens mount (of the holder)until it comes in front of the primary lens of theprojector. Temporarily lock the x-direction fixinglevers to fix the mount. Loosen the right and left hexagon head screws ofthe anamorphic lens holder and move the anamor-phic lens so that the clearance between this andthe primary lens is minimized. Tighten the sidehex screws. Loosen the anamorphic lens setscrew (hexagonhead screw) and turn the lens unit so that the ver-tical and horizontal lines of the center of the im-age projected become perpendicular and level.(To prevent the anamorphic lens from coming off, be sure to holdthe lens while loosening the setscrew.)
