NEC iS8-2K Installation And Adjustment Manual

Contents

NEC iS8-2K Installation And Adjustment Manual Manual pdf 61 page image

61PowerOn --------- Turns the projector‘s power on.Off --------- Turns the projector’s power off.Note:• While your projector is on, be sure to have the lens cap removed from the lens.Otherwise, the lens cap may get deformed due to a heat buildup.• In the following instances, the power to your projector cannot be turned on even if you press the POWER button:• When the inside temperature is abnormally high. The protective function prevents power from turning on.Wait some time (until the projector inside cools down) and then turn on the power.• When the lamp is at the end of its life. Power will not turn on. Replace the lamp with a new one.• When the STATUS indicator is blinking without the lamp lighting up after power-on. Your projector may be in trouble.Check the error display on the LCD screen and contact your dealer/distributor for instructions.• Note that the image may sometimes flicker until the lamp has stabilised (3 to 5 minutes) after power-on.This is due to the characteristics of the lamp and is no trouble of your projector.Picture MuteOn --------- Turn off image projection temporarily.Off --------- The image will be projected again.Note:• When the GPIO control is in “Enable,” the PICTURE MUTE function will not work.ShutterClose ----- The lens shutter will operate to shut off the light for projection.Open ------ Cancel the operation of the lens shutter.Signal SelectTitle List ------- The projector title list is displayed here.Double-click to select the title.Test Pattern -- The test pattern list is displayed here.Double-click to select the test pattern.11. Using the PC Control Software(Menu Descriptions & Functions)11-1. Basic11-1-1. Control