Chapter 1 - Installing the ChassisChapter 1 1 - 211.6.1.2 Installing the Short-Term Battery Box in the 19” Chassis-A● Though the battery cage is provided standard as part of the Chassis-A, the batteries areoptional equipment.1. Make sure the chassis is powered off and unplugged.2. On the back of the 19” Chassis-A, remove the 2 screws holding in the metal plate on the leftside of the chassis.3. Remove the screw holding in the fan’s metal plate. Remove the cover by lifting it on the leftside and sliding it slightly to the right.● Use caution when removing the plate as the fan is attached to this plate but it is stillplugged into the connection on the chassis.4. On the battery box cage, remove the screws holding down the 2 brackets on the top of thebox.5. Install the 2 battery units (2.3AH-12V batteries) into the battery box cage. and reattach the 2brackets to secure the batteries in place.6. Provided with the battery box are 2 cables. Clip the short wire to the batteries at the front.7. With the long 2-wire cable, clip each end to the batteries at the back.Figure 1-24: REMOVE SCREWS ON 19” CHASSIS-AFigure 1-25: BATTERY BOX WITH BATTERIES AND CABLESRemove screws to install
