NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM29From the Alert Settings menu, the user can enable/disable alert messages to be sent when the IP Device is not responding andconfigure when and how alert messages are sent.Figure 28- Text Menu-IP Device Alert SettingsAlert Settings DescriptionDisable alerts Change to “Yes” to prevent alerts from being sent when this IP Device’s status changesNotify Again Time Enter the amount of time in seconds, minutes, or hours (1-999) before an alert message will berepeatedNotify on Return to Normal The user can also be notified when the IP Device’s state has returned to the normal bychanging to “Yes” for "Notify on return to normal" for a sensor.Auto Acknowledge Change to “Yes” to have alert notifications in the summary page return to normal stateautomatically when sensor readings return to normal.Enable Email Alerts Change to “Yes” to have alert notifications sent via EmailEnable Syslog Alerts Change to “Yes” to have alert notifications sent via Syslog messagesEnable SNMP traps Change to “Yes” to have alert notifications sent via SNMP traps (v2c)Email Subject Enter the subject to be viewed when an email alert message is receivedEnable SMS Alerts Change to “Yes” to have alert notifications sent via SMS (requires GSM modem)Siren Change to “Yes” to activate the siren circuit during an alert conditionBeacon Change to “Yes” to activate the beacon circuit during an alert conditionPress <Tab> to highlight Save and press <Enter> to save before pressing <Esc> to exit.
