MCF5253 Evaluation Board Quick Start Guide, Rev. 0The CF Flasher ToolFreescale Semiconductor89. Accept all default options during the installation.10. If prompted, restart your computer.11. Ensure that the icon CF Flasher 3.1 appears on your desktop. If it does not, repeat the steps in thissection.4.2 Connecting Required HardwareCF Flasher communicates with the MCF5253 EVB through the provided P&E USB BDM interface.Follow the steps below to connect the proper components for CF Flasher to operate.1. Connect the standard-A plug of the 6’ USB cable to your computer.2. Connect the standard-B plug of the 6’ USB cable to the P&E USB BDM interface.3. Locate the the BDM port (labeled J12 BDM) on the EVB circuit board.4. Connect the P&E USB BDM interface to the BDM port on the EVB circuit board, making sure thatpin 1 on the interface (as labeled on the tag near the connector) aligns with pin 1 on the port.5. If the EVB has not been connected to its power supply as described in Section 3.2, “Apply Powerto the EVB”, follow the instructions therein to apply power to the EVB.4.3 Transferring the USB Demonstration to the EVBThe USB demonstration is stored as a flash memory image in the CF Flasher folder (see Section 4.1,“Installing CF Flasher”). Follow the instructions in this section to transfer this image to the EVB’s flashmemory.1. Ensure you have completed the steps in Section 4.1, “Installing CF Flasher” and Section 4.2,“Connecting Required Hardware”.2. Start the CF Flasher application. The main CF Flasher window, shown in Figure 7, appears.Figure 7. The CF Flasher Main Window3. Click the Target Config button. The target configuration window, shown in Figure 8, appears.