Napoleon Ascent BHD4PN Installation And Operation Manual

Also see for Ascent BHD4PFCN: Installation and operation manual

Contents

Napoleon Ascent BHD4PN Installation And Operation Manual Manual pdf 35 page image

ENW415-1285 / G / 04.27.1835finishing10.0 finishing• Risk of fire!• Never obstruct the front opening of the appliance.• The front of the appliance must be finished with any non-combustible materials such as brick, marble, granite,etc., provided that these materials do not go below the specified dimension, as illustrated.• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.• Facing and/or finishing material must never overhang into the appliance opening.• The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishingor other materials must not be located in the opening surrounding the door as this will interfere with the doorsability to relieve pressure.! WARNINGA. Remove the door(s), refer to "door removal / installation " section for instructions.B. Cut the strap holding the glass and vent thimble in place.C. Remove the 2 screws holding the shipping bracket / vent shield in place, as shown.NOTE: The two screws removed from the shipping bracket vent shield MUST be replaced.10.1 shipping bracketThe two screws removed from the shipping bracket vent shield MUST be replaced.note:SAFETY SCREENSAFETY SCREENA barrier designed to reduce the risk of burns from the hot viewing glass is provided with theappliance and shall be installed.Before the glass door can be removed, the safety screen must be removed. Lift the safety screen up and pull itout of the bottom retainer. Pull the safety screen down and out of the top retainer.Reverse these steps to reinstall the safety screen. Ensure it is installed correctly.10.2 main safety barrier removal / installation