Napoleon Ascent BHD4PN Installation And Operation Manual

Also see for Ascent BHD4PFCN: Installation and operation manual

Contents

Napoleon Ascent BHD4PN Installation And Operation Manual Manual pdf 43 page image

ENW415-1285 / G / 04.27.1843finishingA. Remove the main safety screen and door from the appliance, see"main safety barrier removal / installation" and "main door removal /installation" sections for detailed removal instructions.HINT: For ease of installation, remove both main doors.B. Place the #3 hearth pad on the pilot side of the burner, as shown inFigure B.C. Place the #1A hearth pad on the right side and the #1 hearth padon the left side of appliance, as shown in Figure C.D. Place the two #2 hearth pads on the right and left sides, as shownin Figure D.E. Place the #4 hearth pad on the left end, as shown in Figure E.BCDE10.11 hearth pad installationFig. 1PINFig. 3PINFig. 2PIN10.12 log placementPhazerTM logs and glowing embers, exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect thatis different in every installation. During the initial use of the appliance, log colours may vary. During the initial use ofthe appliance, the colours will become more uniform as colour pigments burn in during the heat activated curingprocess.Blocked burner ports can cause an incorrect flame pattern.1. Remove the main safety screens and doors, see "main safetybarrier removal / installation" and "main door removal / installation"sections for removal instructions.2. Place a pin into the bottom of log #1 lining it up with the hole in thehearth pad. Then place onto the screw and spacer located in thecorner of the burner, on the right side. Place a pin into the center oflog #1 (FIG.1).3. Place log #2 onto the pin located in the log #1, it should rest in themiddle of the left side hearth pad as shown in Figure 2. Place onepin into the middle of log #2 (FIG.2).4. Place log #3 onto the pin located in log #2 and let it rest on log #2,as shown in Figure 3 and in the left side view below. Place anotherpin into log #2 (FIG.3).! WARNING• Failure to position the logs in accordance with these diagrams or failure to use only logs specifically approvedwith this appliance may result in property damage or personal injury.• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, sinceappliance may not function properly and delayed ignition may occur.• The logs are fragile and should be handled with care.48.1The individual logs can be easily identified by the numbers cast on the underside of each log.note:The pilot is located on the right end in these instructions.note:The pilot is located on the right end in these instructions.note:The individual hearth pads can be easily identified by thenumbers cast on the underside of each pad.note: