Napoleon BGD42CFN Installation And Operating Instructions Manual

Also see for BGD42CFN: Installation and operating instructions Installation and operating instructions Installation and operating instructions Installation and operating instructions Installation and operating instructions

Napoleon BGD42CFN Installation And Operating Instructions Manual Manual pdf 20 page image

20W415-0779 / A / 04.27.104.3 VERTICAL INSTALLATIONThis application occurs when venting through a roof. Installation kits forvarious roof pitches are available from your authorized dealer / distributor. Seeaccessories to order specific kits required.A. Determine the air terminal location, cut and frame a square opening asillustrated in the ceiling and the roof to provide the minimum 1“ clearancebetween the vent pipe and any combustible material. Try to center the ventpipe location midway between two joists to prevent having to cut them. Usea plumb bob to line up the center of the openings. A vent pipe shield willprevent any materials such as insulation, from filling up the 1” air spacearound the pipe. Nail headers between the joist for extra support.B. Apply a bead of caulking (not supplied) to the framework or to the WolfSteel vent pipe shield plate or equivalent (in the case of a finished ceiling),and secure over the opening in the ceiling. A firestop must be placed on thebottom of each framed opening in a roof or ceiling that the venting system passesthrough. Apply a bead of caulking all around and place a firestop spacer overthe vent shield to restrict cold air from being drawn into the room or around thefireplace. Ensure that both spacer and shield maintain the required clearance tocombustibles. Once the vent pipe is installed in its final position, apply sealantbetween the pipe and the firestop assembly.C. In the attic, slide the vent pipe collar down to cover up the open end of the shield and tighten.This will prevent any materials, such as insulation, from filling up the 1” air space around thepipe. 21.1CAULKINGVENT PIPESHIELDFIRESTOPUNDERSIDE OFJOISTVENTPIPECOLLARVENTPIPESHIELD10 3/4" 10 3/4"4.4 USING FLEXIBLE VENT COMPONENTSFor safe and proper operation of the appliance, follow the ventinginstructions exactly.All inner flex pipe and outer flex pipe joints may be sealed using hightemperature sealant W573-0002 (not supplied) or the high temperaturesealant W573-0007 Mill Pac (not supplied). However, the high temperaturesealant W573-0007 Mill Pac (not supplied) must be used on the jointconnecting the inner flex pipe and the exhaust flue collar.Use only approved flexible vent pipe kits marked:“Wolf Steel Approved Venting” as identifiedby the stamp only on the outer flex pipe.22.1ELBOWSPACERSDO NOT ALLOW THE INNER FLEX PIPE TO BUNCH UP ON HORIZONTAL OR VERTICAL RUNS AND ELBOWS.KEEP IT PULLED TIGHT.SPACERS ARE ATTACHED TO THE INNER FLEX PIPE AT PREDETERMINED INTERVALS TO MAINTAIN AN EVENAIR GAP TO THE OUTER FLEX PIPE. THIS GAP IS REQUIRED FOR SAFE OPERATION. A SPACER IS REQUIREDAT THE START, MIDDLE AND END OF EACH ELBOW TO ENSURE THIS GAP IS MAINTAINED. THESE SPACERSMUST NOT BE REMOVED.! WARNING