Napoleon BGD42CFN Installation And Operating Instructions Manual

Also see for BGD42CFN: Installation and operating instructions Installation and operating instructions Installation and operating instructions Installation and operating instructions Installation and operating instructions

Napoleon BGD42CFN Installation And Operating Instructions Manual Manual pdf 6 page image

6W415-0779 / A / 04.27.102.3 GENERAL INFORMATION4.1The installation must conform with local codes or, inabsence of local codes, the National Gas and PropaneInstallation Code CSA B149.1 in Canada, or the NationalFuel Gas Code, ANSI Z223.1 / NFPA 54 in the UnitedStates. Suitable for mobile home installation if installed inaccordance with the current standard CAN/CSA Z240MHSeries, for gas equipped mobile homes, in Canada orANSI Z223.1 and NFPA 54 in the United States.As long as the required clearance to combustibles ismaintained, the most desirable and beneficial location for an appliance is in the center of a building, therebyallowing the most efficient use of the heat created. The location of windows, doors and the traffic flow in theroom where the appliance is to be located should be considered. If possible, you should choose a locationwhere the vent will pass through the house without cutting a floor or roof joist.If the appliance is installed directly on carpeting, vinyl tile or other combustible material other than woodflooring, the appliance shall be installed on a metal or wood panel extending the full width and depth.If the optional fan or blower is installed, the junction box must be electrically connected and grounded inaccordance with local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70 National Electrical code in the United States.We suggest that our gashearth products be installedand serviced by professionalswho are certified in the U.S.by the National FireplaceInstitute® (NFI) as NFI GasSpecialistswww.nficertified.orgThis appliance is approved for bathroom, bedroom and bed-sitting room installations and is suitable for mobilehome installation.No external electricity (110 volts or 24 volts) is required for the gas system operation.Expansion / contraction noises during heating up and cooling down cycles are normal and are to be expected.APPLIANCENG LPAltitude (FT) 0-4,500 0-4500Max. Input (BTU/HR) 24,000 24,000Max. Output Steady State (BTU/HR) 16,000 16,000Efficiency (w/the fan on) 67% 67%A.F.U.E. (Annual Fuel Utilization Efficiency) 54.2% 54.2%Min. Inlet Gas Supply Pressure 4.5" Water Column 11" Water ColumnMax. Inlet Gas Supply Pressure 7" Water Column 13" Water ColumnManifold Pressure (Under Flow Conditions) 3.5" Water Column 10" Water ColumnFOR YOUR SATISFACTION, THIS APPLIANCE HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION ANDQUALITY!