Napoleon EPA 1100 Installation And Operating Instructions Manual

Also see for EPA 1100: Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operating instructions

Napoleon EPA 1100 Installation And Operating Instructions Manual Manual pdf 11 page image

ENW415-1468 / A / 09.30.1611RAIN CAPREMOVE TOALLOW FORTRANSPORATIONMOBILE HOMEROOF FLASHINGRADIATION SHIELDCEILING SUPPORTTRIM COLLARAPPLIANCEBOLTED TO FLOORHEARTH PADOUTSIDE AIR CONNECTIONTHROUGH WALL OR FLOORThe pedestal base must be firmly bolted to the floor with 1/4 inchlag bolts. For specific clearances, see “MINIMUM CLEARANCESTO COMBUSTIBLES” section.The appliance must be installed between ceiling joists, withradiation shield and roof flashing, so that the structural strength,insulation and waterproof qualities of the home are not lessened.Seal with silicone to maintain a vapour barrier at the chimney andoutside air pipe penetrations.Connection from the appliance’s air intake to outside air is mandatory in mobilehomes only, either through a hole in the wall to line up with the knockout in thepedestal back, or through a hole in the floor to line up with the hole in thepedestal base. Use a fresh air kit. Secure the 4” (102mm) diameter aluminumliner by flaring the end once it is inserted through the 4 1/2” (114mm) diameterhole in either the back or base of the pedestal. If the air intake is through thefl oor, the hole in the pedestal back must be covered with sheet metal to avoidcold air spillage into the room. A cover plate is available from your locaauthorized dealer/distributor. Avoid cutting away floor joists, wall studs, electricalwires or plumbing. Seal around the outside pipe with insulation to prevent drafts.Attach the rear knockout plate (located inside the ash pan for shipping purposes).NOTE: The 1450 can only have outside air connected to pedestal backplate. Connection to bottom ofpedestal not available.TRIMPEDESTALKNOCKOUTPLATE3.5.1 OUTSIDE AIR - MOBILE HOME3.6 MOBILE HOME! WARNINGDO NOT INSTALL IN SLEEPING ROOM.THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL AND CEILING/ROOF MUST BEMAINTAINED.THE APPLIANCE MUST BE PROVIDED WITH OUTSIDE COMBUSTION AIR.THE APPLIANCE MUST BE BOLTED TO THE FLOOR.INSTALL ACCORDING TO 24 CFR, PART 3280 (HUD).USE A CHIMNEY CERTIFIED FOR WOOD BURNING UL 103 S629, TYPE HT (2100°F).MODEL 1100 IS APPROVED FOR INSTALLATION IN MOBILE HOMES IN THE UNITED STATES & CANADA.MODELS 1400, 1400C, & 1450 ARE APPROVED FOR INSTALLATION IN MOBILE HOMES IN THE UNITEDSTATES ONLY.MODELS 1150 & 1900 ARE NOT APPROVED FOR INSTALLATION FOR MOBILE HOMES IN THE UNITEDSTATES OR CANADA.NOTE: All mobile home approved appliances must be secured to the floor of the mobile home except formodel 1150.