13W415-0379 / C / 03.12.1058"42½"41"42 ½"22 ½"42 ½"OUTSIDECHASEOUTSIDEOUTSIDEOUTSIDECHASECHASECHASEINSIDECHASEINSIDEINSIDEINSIDECHASECHASECHASE6"22 ½"Minimum clearance to combustible construction from fireplace:sides, back, bottom and top of the unit 0 inchrecessed depth 22 inchesIt is not necessary to install a hearth extension with this fireplace system.When roughing in the fireplace, raise the fireplace to accommodate for the thickness of the finished floor mate-rials, i.e. tile, carpeting, hard wood, which if not planned for will interfere with the opening of the lower accessdoor and the installation of many decorative flashing accessories.Raise the fireplace up to the height of the finished flooring to ensure control access and accessory installations.4.1 MINIMUM CLEARANCE TO COMBUSTIBLES4.2 MINIMUM MANTEL CLEARANCESCombustible materials may be installed flush with the front of the appliance but must not cover any of the blackface-areas of the appliance. Non-combustible material (brick, stone or ceramic tile) may protrude in theseareas.Combustible mantle clearance can vary according to themantle depth. Use the graph to help evaluate the clear-ance needed.MATERIALSSTUDCOMBUSTIBLETOP OF UNIT7” MANTEL6” MANTEL4” MANTEL2” MANTEL7”2”4”6”! WARNINGRISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES. FAILURETO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE A FIRE OR CAUSE THE APPLIANCE TOOVERHEAT. ENSURE ALL CLEARANCES (I.E. BACK, SIDE, TOP, VENT, MANTEL, FRONT, ETC.) ARECLEARLY MAINTAINED.WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BEHEAT RESISTANT TO PREVENT DISCOLOURATION.73.1MANTEL WIDTH4312375675HEIGHTMANTEL