Napoleon GVF42P Installation And Operating Instructions Manual

Also see for GVF42N: Installation and operation instructions Installation and operating instructions

Napoleon GVF42P Installation And Operating Instructions Manual Manual pdf 7 page image

7W415-0379 / C / 03.12.102.5 CARE OF PLATED PARTS6.1If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the platedsurfaces before operating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean.If not cleaned properly before operating for the first time, the marks can cause permanent blemishes onthe plating. After the plating is cured, the fingerprints and oils will not affect the finish and little maintenanceis required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may causediscolouration on plated parts.NOTE: The protective wrap on plated parts is best removed when the assembly is at roomtemperature but this can be improved if the assembly is warmed, using a hair dryer or similar heatsource.2.4 RATING PLATE INFORMATIONWARNING: FIREPLACE SCREENS MUST BE CLOSED WHILE IN OPERATION. DO NOT ADD ANY MATERIAL TO THE APPLIANCE, WHICH WILL COMEIN CONTACT WITH THE FLAMES, OTHER THAN THAT SUPPLIED BY THE MANUFACTURER WITH THE APPLIANCE. DONOT USE BLOWER INSERT, HEAT EXCHANGER INSERT OROTHER ACCESSORIES NOT APPROVED FOR USE WITH THIS HEATER. IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTAINANCE CAN CAUSE PROPERTYDAMAGE, PERSONAL INJURY OR LOSS OF LIFE. REFER TO THE OWNER'S INFORMATION MANUAL PROVIDED WITH THIS APPLIANCE. INSTALLATION AND SERVICE MUST BEPERFORMED BY A QUALIFIED INSTALLER, SERVICE AGENCY OR THE GAS SUPPLIER.W385-0248 / DMADE IN CANADAWOLF STEEL LTD, BARRIE, ON, CANADA SERIAL NUMBER: G/CVF42* MAXIMUM HORIZONTAL EXTENSION: 2". SEE INSTRUCTIONMANUAL FOR GREATER EXTENSIONS.ELECTRICAL RATING: 115V 0.82AMP, 60HZOPTIONAL FAN KIT: GZ550-KTMINIMUM CLEARANCE TO COMBUSTIBLE MATERIALS:TOP / SIDES / BACK / FLOOR 0RECESSED DEPTH 22""2ELTNAM *CERTIFIED UNDER: ANSI Z21.11.2-2007 VOLUME II, UNVENTED ROOM HEATERTHIS APPLIANCE MAY BE INSTALLED IN AN AFTERMARKET,PERMANENTLY LOCATED, MANUFACTURED (MOBILE) HOME, WHERENOT PROHIBITED BY LOCAL CODES. THIS APPLIANCE IS ONLY FOR USEWITH THE TYPE OF GAS INDICATED ON THE RATING PLATE. THISAPPLIANCE IS NOT CONVERTIBLE FOR USE WITH OTHER GASES.THIS IS A GAS-FIRED UNVENTED ROOM HEATER THAT REQUIRESADEQUATE COMBUSTION AND VENTILATION AIR. THIS UNIT IS NOTAPPROVED FOR BEDROOM, BATHROOM AND BED-SITTING ROOM IN-STALLATION.CERTIFIED FOR USAALTITUDEINPUTREDUCED INPUTORIFICE**0-2000FT (0-610m)30,000 BTU/h22,000BTU/h#380-2000FT (0-610m) **30,000 BTU/h22,000BTU/h#53MANIFOLD PRESSURE: 10" WATER COLUMNMINIMUM SUPPLY PRESSURE: 11" WATER COLUMNMAXIMUM SUPPLY PRESSURE: 13" WATER COLUMNSIT CONTROL: #820636OPERATING PILOT OXYPROTECTOR: #8404MANIFOLD PRESSURE: 3.5" WATER COLUMNMINIMUM SUPPLY PRESSURE: 4.5" WATER COLUMNMAXIMUM SUPPLY PRESSURE: 7.0" WATER COLUMNSIT CONTROL: #820637OPERATING PILOT OXYPROTECTOR: # 8214**ABOVE 2,000FT, CONSULT LOCAL AUTHORITY HAVING JURISDICTIONNOT FOR USE WITH SOLID FUEL.MODELGVF42-N / CVF42-NMODELGVF42-P / CVF42-PREFERENCE #15509AINSTALLER: It is your responsibility to check off the appropriate box on the rating plate according tothe model, venting and gas type of the appliance.For rating plate location, see “DIMENSIONS” section.This appliance is equipped with a pilot light safety system referred to as an oxygen depletion sensor and is designed toturn off the appliance if not enough fresh air is available.Use only accessories designed for and listed with your specific appliance.Not designed for use with a glass door. Screens must be closed when appliance is in operation.