W415-1259 / 10.22.1321ENA. Unscrew the 4 screws that hold the AccessPanel to the firebox.B. Remove the Gasket (careful not to tear). AccessPanelGasket4.4 ACCESS PANEL FOR GAS LINE CONNECTION4.3 MOBILE HOMEThis appliance is also certified to be installed as an OEM (Original Equipment Manufacturer) installationin a manufactured home (U.S. only) or mobile home and must be installed in accordance with themanufacturer’s instructions and the Manufactured Home Construction and Safety Standard, Title 24 CFR,Part 3280, in the United States or the Mobile Home Standard, CAN/CSA Z240 MH Series, in Canada. Thisappliance is only for use with the type(s) of gas indicated on the rating plate.29.1AThis Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the unit. Builtin appliances are equipped with 1/4” (6.4mm) diameter holes located in the front left and right corners of thebase. Use #10 hex head screws, inserted through the holes in the base to secure. For free standing productscontact your local authorized dealer / distributor for the appropriate securing kit. For mobile home installations, theappliance must be fastened in place. It is recommended that the appliance be secured in all installations. Alwaysturn off the pilot and the fuel supply at the source, prior to moving the mobile home. After moving the mobile homeand prior to lighting the appliance, ensure that the logs are positioned correctly.This appliance is certified to be installed in an aftermarket permanently located, manufactured (mobile)home, where not prohibited by local codes.This appliance is only for use with the type of gas indicated on the rating plate. This appliance is notconvertible for use with other gases, unless a certified kit is used.A conversion kit is supplied with the mobile home appliance.Conversion KitsThis appliance is field convertible between Natural Gas (NG) and Propane (LP).To convert from one gas to another consult your Authorized dealer/distributor.