Napoleon HDX40NT Installation And Operating Instructions Manual

Contents

Napoleon HDX40NT Installation And Operating Instructions Manual Manual pdf 33 page image

33W415-0869 / A / 06.10.106.5 OPTIONAL ROCK PLACEMENTBefore beginning with the installation, remove the door and all burner media from the unit. eg. logs,charcoal etc. Retain the glowing embers.6.5.1 Remove the grate by removing the 2 screws that secure it. NOTE: All screws must be re-installed tomaintain a firebox seal.6.5.2 Remove the 2 screws from the firebox base (as shown). Install the rock support using the 2 screws.NOTE: The protective plastic coating must be removed prior to operating the appliance.6.5.3 Sit the two rock clusters on top of the rear log support. Ensure the clusters are sitting flat.6.5.4 Place the large notched rocks along the inside and outside edges of the rock support as desired.6.5.5 Place the remaining refractory rocks around the burner as desired, making sure not to cover anyburner ports. (There are no set locations)6.5.6 Re-install the glowing embers over the front burner ports. Refer to your installation instructions ifnecessary. Empty enough sand onto the firebox base to cover all the screw heads. Spread the sandevenly, making sure not to block the air vents.6.5.6 Re-install the door.! WARNINGREAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE.ROCK SUPPORTLOG SUPPORTNotchedRockAIR VENTS1 2435 6 FRONT BURNERPORTS