Napoleon HDX40NT Installation And Operating Instructions Manual

Contents

Napoleon HDX40NT Installation And Operating Instructions Manual Manual pdf 37 page image

37W415-0869 / A / 06.10.108.0 WIRING DIAGRAM / ELECTRICAL INFORMATION! WARNINGDO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIEDSERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THEELECTRICAL CIRCUIT.RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THEAPPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCEWITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIANELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 INTHE UNITED STATES.ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,WITH THE GLASS DOOR OPENED OR REMOVED.69.28.1 WIRING REQUIREMENTS8.1.1 This appliance must be electrically connected and grounded in accordance with local codes. In theabsence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or theANSI/NFPA 70-1996 NATIONAL ELECTRICAL CODE in the United States.8.1.2 Low voltage and 110 VAC voltage cannot be shared within the same wall box.8.1.3 Wire the appliance junction box to 110 VAC for proper operation of the appliance.8.1.4 Refer to “WIRING DIAGRAM” section.8.1.5 This appliance is equipped with an electronic control valve which operates on a 3 volt system.8.1.6 Plug the 3 volt AC transformer into the appliance junction box to supply power to the applianceand install two “D” cell batteries (not included) into the battery tray before use (only required if theappliance is to operate during a power failure).8.2 OPTIONAL ACCESSORIES REQUIREMENTS8.2.1 This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.8.2.2 Wiring for optional Wolf Steel approved accessories should be done now to avoid reconstruction.Follow instructions that come with those accessories.8.2.3 The Battery Tray, IPI Control Module, and Remote Control Receiver can be accessed through the airspace between the firebox front and the lower-front finishing cover panel.8.2.4 The Battery Tray, IPI Control Module,Remote Control Receiver must besecured using Velcro to the inside ofthe lower cover panel.OPTIONAL REMOTE CONTROL RECEIV-ER LOCATION8.2.5 Optional remote control receiverlocations as shown in illustrationbelow.JUNCTIONBOXBATTERYTRAYIPI MODULEGAS VALVEBATTERYRELAYREMOTE CONTROLRECEIVER LOCATIONS