Napoleon IR3N-1 Installation And Operating Instructions Manual

Also see for IR3N-1: Installation and operating instructions

Napoleon IR3N-1 Installation And Operating Instructions Manual Manual pdf 13 page image

W415-1198 / 05.24.1313ENTear the embers into pieces and place along the front row of ports covering all of the burner area in front ofthe small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposededges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame;however, care should be taken to not block the burner ports.Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTMlogs glow when exposed to direct flame. Use only certified "glowing embers" and PHAZERTM logs availablefrom your authorized dealer / distributor.97.1ARemove the backing of the logo supplied and place on the glass viewing door,as indicated.½"(12.7mm)LOGO½" (12.7mm)4.4 OPTIONAL ROCK PLACEMENT4.5 GLOWING EMBERS4.6 LOGO PLACEMENTBefore beginning with the installation, remove the door and all burner media from the appliance including logsand charcoal strips. Retain the glowing embers.D. Reinstall the glowing embers over the burner.E. Reinstall the door.! WARNINGREAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODEA. Sit the two rock clusters on topof the rear log support. Ensure theclusters are sitting flat.B. Place the large notched rocksalong the step behind the frontburner as desired.C. Place the remaining rocks aroundthe burner as desired making surenot to cover any burner ports (thereare no set locations).4.7 BATTERY INSTALLATION4 AA batteries must be installed in to the (DC battery pack) before operation is possible. The battery packis located in the bottom right corner of the appliance. The door may have to be removed to access, refer to"DOOR REMOVAL AND INSTALLATION" section. (Refer to "INSTALLATION OVERVIEW" for battery location).