Napoleon IR3N-1 Installation And Operating Instructions Manual

Also see for IR3N-1: Installation and operating instructions

Napoleon IR3N-1 Installation And Operating Instructions Manual Manual pdf 22 page image

W415-1198 /05.24.1322ENNOTE: Care must be taken when removing and disposing of any broken glass or damagedcomponents. Be sure to vacuum up any broken glass from inside the appliance before operation.A. Place the door frame face down careful not to scratch thepaint.B. Center the gasketed glass inside the door frame with the thickside of the gasket facing up.C. Bend the glass retainers located along the edge of the doorframe over the gasket holding the glass in place. Careful notto break the glass.! WARNINGDO NOT USE SUBSTITUTE MATERIALS.GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS ORDAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THEAPPLIANCE BEFORE OPERATION.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.GLASSGASKETDOORFRAMEGLASSRETAINER8.2 CARE OF GLASS5.1DO NOT CLEAN GLASS WHEN HOT! DO NOT USEABRASIVE CLEANERS TO CLEAN GLASS.Buff lightly with a clean dry soft cloth. Clean both sidesof the glass after the first 10 hours of operation with arecommended fireplace glass cleaner. Thereafter cleanas required. If the glass is not kept clean permanentdiscoloration and / or blemishes may result.HOT GLASS WILLCAUSE BURNS.DO NOT TOUCH GLASSUNTIL COOLED.NEVER ALLOW CHILDRENTO TOUCH GLASS.! WARNING8.3 CARE OF PLATED PARTS6.1If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the platedsurfaces before operating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean.If not cleaned properly before operating for the first time, the marks can cause permanent blemishes onthe plating. After the plating is cured, the fingerprints and oils will not affect the finish and little maintenanceis required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may causediscolouration on plated parts.NOTE: The protective wrap on plated parts is best removed when the assembly is at roomtemperature but this can be improved if the assembly is warmed, using a hair dryer or similar heatsource.8.4 DOOR GLASS REPLACEMENTRefer to "DOOR REMOVAL AND INSTALLATION" section.