Napoleon IR3N-1 Installation And Operating Instructions Manual

Also see for IR3N-1: Installation and operating instructions

Napoleon IR3N-1 Installation And Operating Instructions Manual Manual pdf 17 page image

W415-1198 / 05.24.1317ENA. Using the remote transmitter press the "OFF" button.NOTE: To turn the appliance on after pressing the "OFF" button, you must wait 30 seconds. Theappliance will shut off if no change has occured to the flame height or if the appliance has not turnedon for a period of 5 days.A. Press the "Set" button to change modes.B. The modes change in the following order:NOTE: Refer to "GENERAL REMOTE TRANSMITTER LAYOUT".MAN TEMP TEMP TIMER MAN• For flame height adjustment in Manual Mode MAN double click the large flame button toincrease to the highest flame height. Double click the small flame button to decrease to thelowest flame height. Press the large flame button to increase flame height or the small flamebutton to decrease flame height. NOTE: Holding the small flame button for too longwill switch the appliance to pilot mode. To turn the appliance off completely press the"OFF" button.• For Daytime Temperature Mode TEMP the appliance must be set to standby mode (pilotignited). The default temperature setting for this mode is 23°C / 74°F. (Daytime Temperaturemode is set by comparing the set temperature and room temperature, the flame height is thenadjusted automatically to achieve this Daytime Temperature setting.)• For Nighttime Temperature Mode TEMP the appliance must be set to standby mode (pilotignited). (Nighttime Temperature mode is set by comparing the night time set temperature androom temperature, the flame height is then adjusted automatically to achieve this NighttimeTemperature setting.)• Timer Mode TIMER the appliance must be set to standby mode (pilot ignited). There are twotimer settings available (P1 and P2) allowing the appliance turn off and to turn on at specifiedtimes. NOTE: The "TIMER DISPLAY" indicates the set temperature every 30 seconds.6.2.3 TURNING "ON" THE APPLIANCEA. Place the "ON/OFF" switch in the "ON" position by the receiver, refer to "INSTALLATION OVERVIEW"for location.B. Using the remote transmitter simultaneously press the large flame button and the OFF button untilyou hear a short beep, this confirms the start of the appliance, you can then release both buttons. (Theignition process has begun once continuous beeping has begun).C. Wait several seconds for the appliance to ignite. After main ignition the remote will default to theDaytime Temperature Mode TEMP .NOTE: Refer to "GENERAL REMOTE TRANSMITTER LAYOUT".6.2.4 TURNING "OFF" THE APPLIANCE6.2.5 HAND HELD REMOTE TRANSMITTER OPERATIONS