Napoleon Inspiration ZC Series Installation And Operation Manual

Also see for GDIZCN-SB: Installation and operation manual

Napoleon Inspiration ZC Series Installation And Operation Manual Manual pdf 10 page image

W415-1366 / D / 12.07.18EN10installation2.3 gas installationThe appliance may now be pushed into its final position inside the wood burningappliance. Secure the appliance to the fireplace using perforated strapping attached tothe two securing holes on either side of the appliance as shown. We recommend that thetrim be installed before the appliance is placed into its final position.S E C U R I N GHOLES! WARNING• Risk of fire, explosion, or asphyxiation. Ensure there are no ignition sources such as sparks or open fl ames.• Support gas control when attaching gas supply pipe to prevent damaging gas line.• Always light the pilot whether for the first time or if the gas supply has run out with the glass door openedor removed. Purging of the gas supply line should be performed by a qualified service technician. Ensurethat a continuous gas flow is at the burner before closing the door. Ensure adequate ventilation. For gas andelectrical locations, see “dimensions” section.• All gas connections must be contained within the appliance when complete (gas fireplaces only).• High pressure will damage valve. Disconnect gas supply piping before testing gas line at test pressures above1/2 PSIG.• Valve settings have been factory set, do not change.Installation and servicing to be done by a qualified installer.• Move the appliance into position and secure.• If equipped with a flex connector, the appliance is designed to accept a 1/2” (13mm) gas supply. Without theconnector, it is designed to accept a 3/8” (9.5mm) gas supply. The appliance is equipped with a manual shutoff valve to turn off the gas supply to the appliance.• Connect the gas supply in accordance to local codes. In the absence of local codes, install to the currentCAN/CSA-B149.1 Installation Code in Canada or to the current National Fuel Gas Code, ANSI Z223.1 / NFPA54 in the United States.• When flexing any gas line, support the gas valve so that the lines are not bent or kinked.• The gas line flex-connector should be installed to provide suffi cient movement for shifting the burner assemblyon its side to aid with servicing components.• Check for gas leaks by brushing on a soap and water solution. Do not use open flame.2.4 optional wall switch! WARNING• Do not connect either the wall switch, thermostat or gas valve directly to 110 volt electricity.For ease of accessibility, an optional remote wall switch or millivolt thermostat may be installed in a convenientlocation. Route a 2 strand, solid core millivolt wire from the valve to the wall switch or millivolt thermostat. Therecommended maximum lead length depends on wire size:WIRE SIZE MAX. LENGTH14 gauge (1.8mm) 100 feet (30.5m)16 gauge (1.5mm) 60 feet (18.3m)18 gauge (1.2mm) 40 feet (12.2m)Disconnect the existing wires from terminals 1 and 3 (from theON/OFF switch) and replace with the leads from the wall switch / millivolt thermostat.ADD IMAGEHEREPILOT312