W415-1366 / D / 12.07.18EN8installation2.0 installation2.1 levelling the appliance! WARNING• Risk of fire! Maintain specifi ed air space clearances to vent pipe and appliance.Clean out ashes from the inside of the wood-burning appliance. Make sure that the chimney and wood-burningappliance are in a clean and sound condition and constructed of non-combustible materials. If necessary have anyrepair work done by a qualifi ed person before installing the insert. Remove the existing appliance damper or lockinto an open position.Using screws, attach the appliance warning tag to the insideof the firebox of the appliance into which the insert is beinginstalled.The sheet-metal parts of the appliance, in which the gasappliance insert is to be installed, must not be cut.If the wood-burning factory-built appliance has no gas accesshole(s) provided, an access hole of 1½ inch (38.1mm) or lessmay be drilled through the lower sides or bottom of the appliance in a proper workman like manner. This accesshole must be plugged with non-combustible insulation after the gas supply line has been installed.Ensure that existing chimney cleanouts fit properly.The refractory, glass doors, screen rails, screen mesh and log grates may be removed from the existing appliancebefore installing the gas appliance insert.Smoke shelves, shields and baffles may be removed if attached by mechanical fasteners.The ventilation openings in the existing appliance may be obstructed by the backer plates, aluminium trim etc. butthese parts are not to be applied so as to have an airtight seal.W385-0199Have an authorized dealer install the appliance. If you install the appliance yourself, have your dealer review yourinstallation plans and/or installation. Draw out a detailed plan of the installation including dimensions and verify thedimensions with the requirements listed in this manual.You may wish to adjust the appliance position slightly to ensure the vent does not intersect with a framingmember. Appliance must be positioned so that no combustibles are within, or can swing within (e.g. drapes,doors), 48” (121.9cm) of the front of the appliance.Inserts only: This appliance is equipped with levelling screws, level the appliance before installing into the finalposition. Levelling the appliance will eliminate rocking or excessive noise when the fan is in operation. Once theappliance is level, move it partially into place to allow for all connections to be made. It is not practical to level theappliance once it has been installed. Determine the required depth prior to installing the appliance and adjust thelevelling screws accordingly.WARNING: THIS FIREPLACE HAS BEEN CONVERTED FOR USE WITH AGAS FIREPLACE INSERT ONLY AND CANNOT BE USED FOR BURNINGWOOD OR SOLID FUELS UNLESS ALL ORIGINAL PARTS HAVE BEENREPLACED AND THE FIREPLACE IS RE-APPROVED BY THE AUTHORITYHAVING JURISDICTION.ATTENTION: CE FOYER A ETE CONVERTI AFIN D'ETRE UTILISESEULEMENT COMME FOYER ENCASTRE AU GAZ ET NE PEUT ETRE UTILSEPOUR BRULER DU BOIS OU TOUT AUTRE COMBUSTIBLE SOLIDE, SANSQUE TOUTES LES PIECES ORIGINALES AIENT ETE REMPLACEES ET QUELE FOYER SOIT APPROUVE DE NOUVEAU PAR LES AUTORITES AYANTJURIDICTION. W385-0199