Napoleon Oakville GDIG3 Series Owner's Manual

Also see for Oakville Series: Installation manual Owner's manual Owner's manual Installation manual Installation manual

Napoleon Oakville GDIG3 Series Owner's Manual Manual pdf 12 page image

W415-1867 / B / 02.07.19EN12remote control layout5.4 temperature displayA. With the system in the off position, press the temperature keyand the mode key at the same time to change from degrees F toC.B. Look at the LCD screen on the transmitter to verify that a C or F isvisible to the right of the room temperature display.73 23°F °C5.5 flame height5.6 blower speedIf the appliance is equipped with a hot air circulating fan, the speed ofthe fan can be controlled by the remote system. The fan speed can beadjusted through six (6) speeds.A. Use the mode key to guide you to the fan control icon.B. Use the up/down arrow keys to turn on/off or adjust the fanspeed. A single “beep” will confirm reception of the command.76°F68 76°FHiWhen the desired blower speed is selected, the blower will automatically come on 5 minutes after the mainburner has been turned on and remain on twelve minutes after it has been turned off.note:The remote control has six (6) flame levels. With the system on and the fl ame level at the maximum, press thedown arrow key once and it will reduce the flame height by one step until the fl ame is turned off.The up arrow key will increase the flame height each time it is pressed. If the up arrow key is pressed whilethe system is on but the flame is off, the fl ame will come on at the high position. A single “beep” will confi rmreception of the command.76°FOFF 76°F76°F76°FHiFlame Off Flame at level 1 Flame at level 5 Flame at “Hi” level 6ADD TITLE: Night Light Dimmer Control76°FOFF 76°FThe auxiliary function controls the Night Light™ with dimmable control.A. Use the mode key to guide you to the Night Light™ icon.B. The intensity of the output can be adjusted through 6 levels.Use the up/down arrow keys to adjust the output level. A single beepwill confirm reception of the command.5.7 night light dimmer controlADD TITLE: IN THE EVENT OF A POWER FAILUREIf the receiver is equipped with batteries they will enable flame height control or on/off function to control theappliance during a power failure. Blower and Night Light™ operation is not possible. Refer to “applianceoperation” section when communications between receiver and transmitter have been lost. The receiver willemit a “beep” sound to confirm programming has been successful once power is restored. During a powerfailure, if the appliance was on, the flame height will stay at the setting prior to the failure. If off when the failureoccurs and then turned on, the flame height will come on at “Hi”. The flame height can then be controlled by theremote.5.8 in the event of a power failurenote:Your new fi replace includes a night light that allows you to enjoy the appearance of your fi replace when thefl ames are not on.note:Please note the night light is not designed to be in used whilst the fireplace is burning. The fi replace, logs, andfl ame have been designed to produce the most aesthetically appealing look without the need of the night light.If the night light is used at the same time as the fireplace is burning, the life time of the night light bulb will besignificantly reduced and the need to replace the bulb will become more frequent.When the desired blower speed is selected, the blower will automatically come on 5 minutes after the mainburner has been turned on and remain on twelve minutes after it has been turned off (thermostat mode only).