National Instruments NI Vision CVS-1450 Series User Manual

Also see for NI Vision CVS-1450 Series: Quick start guide Getting started Quick start guide User manual User manual

Contents

National Instruments NI Vision CVS-1450 Series User Manual Manual pdf 27 page image

Chapter 2 Setup and Configuration© National Instruments Corporation 2-13 NI CVS-1450 Series User ManualVision Builder AI: Setting up the Development ComputerThis section describes the sequence for installing Vision Builder AI and theNI-IMAQ for IEEE 1394 Cameras software on the development computer,obtaining an IP address, installing software on the CVS-1450 device, andconfiguring the CVS-1450 device to acquire an image using VisionBuilder AI.Note This section applies only to Vision Builder AI users. If you are using the LabVIEWReal-Time Module with the Vision Development Module, refer to the LabVIEW Real-TimeModule with the Vision Development Module: Setting up the Development Computersection.The following items are necessary for setting up the developmentcomputer.❑ Vision Builder AI, version 2.0 or later❑ NI-IMAQ for IEEE 1394 Cameras driver, version 1.5 or laterInstalling Vision Builder AI and NI-IMAQ for IEEE 1394 CamerasThis section describes how to install the Vision Builder AI software and theNI-IMAQ for IEEE 1394 Cameras driver software onto the developmentcomputer.Note You must install Vision Builder AI before installing NI-IMAQ for IEEE 1394Cameras.Complete the following steps to install Vision Builder AI and NI-IMAQ forIEEE 1394 Cameras onto the development computer.1. Insert the Vision Builder AI CD into the CD-ROM drive.2. When the installation splash screen appears, click Install NI VisionBuilder AI and follow the setup instructions.3. Insert the NI-IMAQ for IEEE 1394 Cameras CD into the CD-ROMdrive.Note When installing NI-IMAQ for IEEE 1394 Cameras, make sure to install the supportfiles for the LabVIEW Real-Time Module.