National Instruments NI Vision CVS-1450 Series User Manual

Also see for NI Vision CVS-1450 Series: Quick start guide Getting started Quick start guide User manual User manual

Contents

National Instruments NI Vision CVS-1450 Series User Manual Manual pdf 31 page image

Chapter 2 Setup and Configuration© National Instruments Corporation 2-17 NI CVS-1450 Series User ManualTip To uniquely identify unconfigured CVS-1450 devices, connect and configure oneCVS-1450 device at a time.3. In the Network Settings window, enter a name for the device in theName field and a description of the device in the Comment field.Note Device names are limited to 15 characters with no spaces or special characters.The first and last characters must be alphanumeric.4. If the network is configured to issue IP addresses using DHCP, selectObtain IP address from DHCP server. Otherwise, set the IP addressmanually by selecting Edit the IP settings, Suggest Values, and OK.5. Click Apply.6. When prompted, click Yes to restart the CVS-1450 device. Thisinitialization process takes several minutes.While the CVS-1450 device is restarting, an icon appears next to the devicename to indicate that the CVS-1450 device is disconnected. The MAXstatus bar also indicates the connection status of the CVS-1450 device.Downloading Software onto the CVS-1450 Device1. In the MAX configuration window, click the Software tab. Thiswindow displays the status of the software on the CVS-1450 device.2. Click the Install Software button.3. Select the software to download. For initial installation, make sure allcheckboxes are selected.4. Click OK.5. When prompted, click Yes to restart the CVS-1450 device. Thisprocess takes several seconds.Acquiring an Image Using the LabVIEW Real-TimeModuleComplete the following steps to acquire an image using the LabVIEWReal-Time Module.1. Launch LabVIEW by navigating to Start»Programs»NationalInstruments LabVIEW.2. Expand the Execution Target drop-down listbox, and click SelectTarget with Options.