Using the Navigate ModeAlternatively, you can also navigate Channel properties and Plug-ins along with their Parameterpages via the Navigate mode of your controller:1. Press SHIFT + VARIATION to enter Navigate mode (or pin it by pressing NAVIGATE +Button 1).2. Press SHIFT, then Button 2 (PAGE NAV) to enter Page Navigation mode.3. Press the CHANNEL button to display the Channel properties or the PLUG-IN button todisplay the Plug-in slots of the selected Sound, Group or the Master.4. Press Button 5/6 to navigate the Channel properties or Plug-ins.The name of the selected Channel properties or Plug-in appears between the left and rightarrows under Button 5 and 6. Furthermore this Plug-in or set of Channel properties ishighlighted on the left display.5. Press the dimmed pads to select the desired Parameter pages. The names of the availableParameter pages are shown on the right display along with the corresponding pads.6. Upon your selection the corresponding pad turns fully lit and the page name is highlight-ed on the right display.7. If there are more than 16 Parameter pages, press Button 7/8 to switch to the previous/next 16 pages, respectively.8. Release the VARIATION button to get back to Control mode (or press VARIATION a sec-ond time if you pinned the Navigate mode).→ The selected Parameter page now appears on the displays. Use Knobs 1–8 under the dis-plays to adjust its parameters.2.3.8.1 Extended Navigate Mode on Your ControllerThe Navigate mode on your controller can be used to navigate the Parameter pages of Channelproperties and Plug-ins and adjust the view settings of specific areas in the software interface.► Press and hold SHIFT + NAVIGATE to enter Navigate mode. You can also pin Navigatemode by pressing SHIFT + NAVIGATE + Button 1 above the left display so that your con-troller stays in Navigate mode when you release NAVIGATE — see section ↑2.3.2, Pin-ning a Mode on the Controller.Basic ConceptsCommon OperationsMASCHINE - Manual - 52
