132 Version 2.0Operator’s Manual ConfigurationAlarm If No Data: Allows you to receive an audible and visual alarm ifNMEA 0183 data is not being received on the data port at regularintervals (typically every few seconds). The available choices areYes (default) or No.AWA Offset: Allows you to input a constant angle correction value.AWS Correction Factor: Allows you to input a wind speed correctionfactor.Input Sentence: Specifies the NMEA 0183 data sentence to read thedepth data from. The available choices are Any (default), MWV, orVWR sentence. It is better to specify the appropriate sentence,because more than one method of reporting wind may be availableon the port.Wpt & Rte Input - Uploading Waypoints into the ReceiverThis screen enables the input data port to receive waypoints and routesfrom a chart plotter, PC (VMS), or other device to the receiver. You canreceive this data through any of the user NMEA 0183 input data ports.Load the WPL sentences first, then the RTE sentences. Change Trans-ducer Connected from No (default) to Yes and select the appropriateport. Refer to the Waypoints - Uploading Waypoints from Other De-vices section of this manual for more details on the software interface.Refer to the Installation & Service Manual for hardware interface.
