Navman iCN 630 User Manual

Also see for iCN 630: User manual User manual Quick start guide Brochure & specs Brochure

Navman iCN 630 User Manual Manual pdf 19 page image

19 iCN 630 user manual-ver 0.12NAVMANINSTALLING THE iCN 630 IN YOUR VEHICLEBefore installing the iCN 630 In-Car navigation unit, check whether your vehicle is fitted with anathermic (heat reflecting) or a heated windshield. If so, you will need to purchase an externalor re-radiating antenna to allow your iCN 630 unit to pick up the GPS signals. For moreinformation, refer to Section 14 Accessories.Your iCN 630 unit comes with mounting options that allow you to install the unit in threedifferent ways: By suction straight onto the windshield. By suction or an adhesive disc onto the dash. By directly screwing onto the dash.Alternative mounting options may be available specifically for your make and model of vehicle.Follow these mounting instructions carefully to ensure your unit is properly installed.For security purposes and to avoid overheating, do not leave this unit on the dash orwindscreen while your vehicle is unattended, especially in strong sunlight. Do not use or handleif the unit is hot - leave it to cool out of the sun.If your unit does get too hot then you will be prompted to turn down the brightness (press andhold the zoom [icon] key). If the unit continues to get hotter the screen will go blank - voiceinstructions will continue.Suction Mount to Windshield1 Choose a position on the windshield where the iCN 630 will be clearly visible by the driver.Follow the safety guidelines at the front of this manual to ensure that the unit does notobstruct the view of the driver, or interfere with the operation of any airbags and safetydevices in the vehicle.2 Make sure that both the windshield and the suction cup are thoroughly clean and dry.3 Hold the suction cup firmly against the windshield and press the lever down untilit snaps shut.4 The ball foot should now be securely fixed on the windshield.5 Slip the locking nut loosely over the ball foot, with the flat side facing upwards.4To remove the suctioncup, pull the lever up.Release the suctionusing release tab.LeverSuction cupLocking nutýShould you experienceproblems with yoursuction cup hot holdingon, clean an area ofyour windshield witha cloth dabbed inisopropyl alcohol [tapehead cleaner] let itdry, then re-apply thesuction cup.