Navman iCN 630 User Manual

Also see for iCN 630: User manual User manual Quick start guide Brochure & specs Brochure

Navman iCN 630 User Manual Manual pdf 21 page image

21 iCN 630 user manual-ver 0.12NAVMANSuction or Adhesive Mount to Dash1 Choose a position on the dash where the iCN 630 will be clearly visible by the driver.Follow the safety guidelines at the front of this manual to ensure that the unit does notobstruct the view of the driver, or interfere with the operation of any airbags and safetydevices in the vehicle.2 Make sure that both the dash and the suction cup are thoroughly clean.3 Suction Mount: if the location you have chosen is flat enough, you can simply use thesuction cup to mount the unit directly onto the dash.4 Adhesive Mount: If the location you have chosen is not suitable to use the suction cupalone, stick the sucker pad down first to give a flat surface. Do this by removing theprotective layer from the adhesive tape on the underside of the sucker pad, and pressingthe sucker pad firmly down for 30 seconds in the desired position on the dash.NOTE: this is a permanent solution the adhesive tape and sucker pad cannot beremoved from the dash once fixed.5 Hold the suction cup firmly against the dash or centrally on the sucker pad, and press thelever down until it snaps shut.6 The ball foot should now be securely fixed. Slip the locking nut loosely over the ball foot,with the flat side facing upwards.7 Snap the socket clip onto the ball foot.8 Adjust the position of the socket clip, so that the unit will be clearly visible by the driver.9 Wind the locking nut onto the thread of the socket clip until firm.To remove the suctioncup, pull the lever up.Release the suctionusing release tab.Make sure theshort side ofthe socket clipis on topPush thesocket clip ontothe ball until itclicksSucker padSuction cupLeverLocking nutý