Nedap uPASS Access Installation Manual
Also see for uPASS Access: Installation guideInstallation guide
                   | |
uPASS Access© Nedap AVI Page 15 of 195.2.3 RELAY / TIMINGConfigure relay output and timing parameters.Figure 9: Relay / timing settingsEnable 'Automatic relay activation' to activate the relay upon identification. When disabled the relay can only beactivated manually.The 'Relay hold time' setting is the minimum time the relay is activated.The 'Vehicle hold time' setting is the time, after a vehicle-id tags has been found, for which the reader will searchfor driver-id tags. This setting is only used in the NEDAP DUAL-ID mode. Introduced in firmware version 2.29.The (random) RF off time parameter can be used to enable time sharing between multiple readers on the samefrequency.5.2.4 LED CONTROLOnly for UPASS ACCESS: setup LED control mode.Automatic mode:Default the uPASS Access will automatically control the LED.During stand-by the LED will be BLUE and upon identification it will be GREEN. These colors can be changed!Figure 10: LED controlRemote control:The LED can be controlled remotely by a connected access control system. Digital inputs will determine thecolor indicated on the LED. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine