Nedap uPASS Access Installation Manual
Also see for uPASS Access: Installation guideInstallation guide
                   | |
uPASS Access© Nedap AVI Page 16 of 195.3 EXPERT SETTINGSClick 'Options', 'Usermode', 'Expert' to show additional configuration settings for advanced users.5.3.1 OUTPUTConfigure communication output settings.Figure 11: Output settingsSelect 'Enable serial id-events' to enable the serial output upon identification. Only disable the serial id-events tooptimize the identification speed when using the wiegand or magstripe interface or the TRANSIT compatibleprocessor.When 'Fast repeat serial id-events' is selected (default) the serial output is repeated upon every identification.When this option is disabled, the message is only sent once.Enable 'Repeat using hold-time interval' to repeat id-events with hold-time interval. The repeating will beenabled for the serial and also for the wiegand or magstripe interface.'Enable vehicle id-events' allows enabling or disabling the id-event messages for vehicle-ids. This may be usefulin combination with the NEDAP DUAL-ID mode and an access control panel that does not support the dual-idfeature.5.3.2 OUTPUT MESSAGE FORMATConfigure output message format.Figure 12: Output message formatThe output message format is configurable: |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine