E-PAK 150 DX/300 DX/500 DX27ENout any maintenance. Keep the manual where it is always close at hand.Replace it immediately if lost.NOTE! Read Chapter ‘4 Safety’!This product has been designed to meet the requirements of the relevant ECdirectives. To maintain this status, all installation, repair and maintenancework is to be carried out by qualified personnel using only original Nedermanspare parts. Contact your nearest authorized distributor or Nederman foradvice on technical service or if you require help with spare parts.Many hours have been spent on the design and production of this product inorder to make it as efficient and safe as possible. Accidents that occur despitethis are usually caused by individuals. A safety-conscious person and a well-maintained product make a safe and effective combination.We continuously improve our products and their efficiency through theintroduction of design modifications. We reserve the right to do this withoutintroducing these improvements on previously supplied products. We alsoreserve the right, without previous notice, to modify data and equipment, aswell as operating and maintenance instructions.3 Hazard noticesThis document contains hazard information which must be read by all users.The hazard information is presented as a warning, caution or note as follows:WARNING! Type of injury.Warnings indicate a potential hazard to the health and safety of users.They clearly state the nature of the hazard and how to avoid it. They appear attheir points of application in this document. They look like this notice, but withdifferent texts.CAUTION! Type of risk.Cautions indicate a potential hazard to the physical integrity of the equipment,but not a danger to personnel. They clearly state the nature of the hazard andhow to avoid it. They appear at their points of application in this document.They look like this notice, but with different texts.NOTE! Notes contain other information which the user should be especiallyaware of.4 SafetyTo maintain a high level of safety when using E-PAK 150 DX/300 DX/500 DX,consider the following:• This unit is to be installed, used and maintained according to thisdocument in such a way that safety is maintained. This document containsimportant warning directions which have to be observed. Any functionalfaults, especially those affecting the safety of the machine, are to berectified immediately.• We recommend that fire alarms and appropriate extinguishing systems areto be installed at all locations where collected combustible dust is stored.• Standards relating to the connection and use of filters in hazardousareas are to be taken into consideration, especially national standards