Nederman E-PAK 300 DX Instruction Manual

Also see for E-PAK 150 DX: Instruction manual

Nederman E-PAK 300 DX Instruction Manual Manual pdf 42 page image

E-PAK 150 DX/300 DX/500 DXEN42To reset the control system, turn the standby and reset switch to position Reset.Restart the unit by turning the standby and reset switch to position 1.NOTE! If the cause of the fault is not eliminated, the unit will immediately goback to fault signal mode and stop.The yellow fault indicator light will be reset automatically once the controlfilter is replaced and the cause of the pressure drop over the control filter isremoved.10 MaintenanceWARNING! Risk of personal injuries.Use proper protective equipment when risking exposure to the dust.WARNING! Risk of electric shock.Work with electric equipment is to be carried out by a qualified electrician.WARNING! Risk of electric shock.Always disconnect the supply voltage with the maintenance switch before anyservice, whether mechanical or electrical. Always lock the maintenance switchin the off position.WARNING! Risk of personal injuries.Ensure that there is no vacuum present in the system during service.WARNING! Risk of personal injuries.Always disconnect the compressed air supply before any service.WARNING! Risk of explosion.Personnel operating E-PAK 150 DX/300 DX/500 DX is to pay special attentionto avoiding discharge of static electricity. The requirements for the safe useand handling of combustible dust is described in the explosion protectiondocument. All personnel is to be informed.WARNING! Risk of explosion.Stop operation and clean the entire filter thoroughly from dust before anygrinding, welding or other hot works are performed on the filter exterior orinlet.10.1 Service and maintenance of ATEX equipmentTo ensure the required level of protection, ensure that the following isperformed:• E-PAK 150 DX/300 DX/500 DX is regularly inspected for damage ormalfunction. If E-PAK 150 DX/300 DX/500 DX is damaged, it is to beshut down and any explosive atmosphere removed.• There is to be no explosive atmosphere and/or dust layers present whenservicing or inspecting E-PAK 150 DX/300 DX/500 DX.• Only Nederman original spare parts are to be used.• E-PAK 150 DX/300 DX/500 DX is not be covered with thick dust layers(>5 mm). This is prevented by setting up routines for regular cleaning andincluding these in the explosion protection document.