Security 11-167Deleting filtersTo delete a filter, select Delete Input Filter or Delete Output Filter in the Display/Change Filter Set screen todisplay a table of filters.Select the filter from the table and press Return to delete it. Press Escape to exit the table without deleting thefilter.Moving filtersTo reorganize the filters in a filter set, select Move Input Filter or Move Output Filter in the Display/ChangeFilter Set screen to display a table of filters.Select a filter from the table and press Return. Then use the up or down arrow key to change the filter’s orderin the filter set. Press Return to accept the new filter location.Deleting a filter setNote: If you delete a filter set, all of the filters it contains are deleted as well. To reuse any of these filters inanother set, before deleting the current filter set you’ll have to note their configuration and then recreate them.To delete a filter set, select Delete Filter Set in the Filter Sets screen to display a list of filter sets.Select a filter set from the list and press Return. Select CONTINUE and press Return to delete it.A sample filter setThis section contains the settings for a filter set called Basic Firewall, which is part of the Netopia 4553’sfactory configuration.Change FilterEnabled: NoForward: NoSource IP Address: 0.0.0.0Source IP Address Mask: 0.0.0.0Dest. IP Address: 0.0.0.0Dest. IP Address Mask: 0.0.0.0Protocol Type: 0Source Port Compare... No CompareSource Port ID: 0Dest. Port Compare... No CompareDest. Port ID: 0Enter the IP specific information for this filter.
