5-28 User’s Reference GuideLaunch your terminal emulation software and configure the communications software for the values shown inthe table below. These are the default communication parameters that the Netopia 4553 uses.Navigating through the console screensUse your keyboard to navigate the Netopia 4553’s configuration screens, enter and edit information, and makechoices. The following table lists the keys to use to navigate through the console screens.Parameter Suggested ValueTerminal type PC: ANSI-BBSMac: ANSI, VT-100, or VT-200Data bits 8Parity NoneStop bits 1Speed 9600 - 57600 bits per secondFlow Control NoneNote: The router firmware contains an autobaud detection feature. If you are at anyscreen on the serial console, you can change your baud rate and press Return(HyperTerminal for the PC requires a disconnect). The new baud rate is displayed atthe bottom of the screen.To... Use These Keys...Move through selectable items in a screen or pop-up menu Up, Down, Left, and Right ArrowSet a change to a selected item or open a pop-up menu ofoptions for a selected item like entering an upgrade keyReturn or EnterChange a toggle value (Yes/No, On/Off) TabRestore an entry or toggle value to its previous value EscMove one item up Up arrow or Control + KMove one item down Down arrow or Control + ODisplay a dump of the device event log Control + EDisplay a dump of the WAN event log Control + FRefresh the screen Control + L
