11-6 User’s Reference GuideConfiguring AppleTalkAppleTalk setup for Netopia R7100s consists of configuring EtherTalk, LocalTalk, and AURP.EtherTalk setupIn the System Configuration screen, select Network Protocols Setup and then select AppleTalk Setup. SelectEtherTalk Phase ll Setup and press Return. If you are using EtherTalk Phase ll on the Ethernet network connected to the Netopia R7100, selectEtherTalk Phase ll Enabled and toggle it to On. To view the zones available to EtherTalk Phase ll, select Show Zones and press Return. You can dismissthe list of zones by pressing Return or Escape. Select Enter New Zone Name to enter a new zone name.Note: Your EtherTalk network number and zone name must match the values in use on the EtherTalknetwork.If another router is already present on the EtherTalk network that you will be connecting to the NetopiaR7100, use the zone names and network numbers used by that router for that EtherTalk network.Otherwise, your EtherTalk network may experience routing conflicts. The Netopia R7100 supports creatingup to 32 zone names.As an alternative, you can set EtherTalk seeding to soft seeding and let the Netopia R7100 receive thezone name and network number from the other router. To remove zones from the list, select Delete Zone Name and press Return to see the zones list. Use theUp and Down Arrow keys to select the zone to delete. Press Return to delete it and exit the list. PressEscape to exit the list without deleting any zones. Select Set Default Zone to choose a different default zone. This is the zone where the Netopia R7100’sEtherTalk Phase II SetupEtherTalk Phase II Enabled: +---------ET II Zone List----------++----------------------------------+Show Zones... | Unnamed || |Enter New Zone Name: | || |Delete Zone Name... | || |Set Default Zone... | || |Net Low: | |Net Hi: | || |Seeding... | |+----------------------------------+Up/Down Arrow Keys to select, ESC to dismiss.
